RF Receiver 315 MHZ - 4 Channel

The RXC6 Wireless RF Receiver Module is a high-sensitivity, 4-channel receiver operating at 315 MHz. Its integrated 4-bit decoding and excellent signal-to-noise ratio, thanks to the Superheterodyne Receiver, make it a reliable choice for your remote control and home automation applications.

Quick Spec

• Frequency: 315Mhz
• Operating voltage: 3 to 5.5V DC
• Quiescent Current: 4mA
• Receiver sensitivity:-105DB
• Size: 30 x 14 x 7mm
• External antenna: 32CM single core wire, wound into a spiral

RXC6 Board Layout

Pin Functions

• 1 ANT - External Antenna - Spiral 32cm
• 2 GND - Ground
• 3 External LED
• 4 External Switch for programming mode
• 5 VT: Will flash when signal receive
• 6 Data D0
• 7 Data D1
• 8 Data D2
• 9 Data D3

Jumper Settings - Directly Translated from Chinese

Supports different modes (Momentary, Latching, Toggle) depending on jumper settings

• T2 & T1 Open - Momentary Default
• T2 Closed, T1 Open - Latching Mode
• T2 Open, T1 Closed - Toggle Mode

Learn button

Learning Mode:

•  Press and hold the learn button on the RXC6 module for 2 seconds. The indicator light should turn on, indicating that the module has entered learning mode.
• Release the learn button and press any button on your remote control. The indicator light on the module should flash four times, indicating that the module has successfully learned the remote control's code and exited learning mode.

Reset:

• Press and hold the learn button on the RXC6 module until the indicator light turns off (about 8 seconds). This should clear all previously learned codes from the module.