Diy Lm1875t Amplificador Potencia Audio 30w Mono Para Armar Itytarg

This product circuit and PCB layout originated from Europe and America, LM1875T classic design for Europe and America!Reasonable wiring!Outstanding performance!Since its release in 2007, it has been highly sought after by DIY enthusiasts.Retain all the original wiring, maximize the original performance under the premise of compression of the entire board size!Make it more DIY!At the same time also on the original components to enhance oh!

Performance parameters:
Output power: typical 20W (Max. 30W)
The speaker impedance: 4 Ω - 8 Ω
Total harmonic distortion: < 0.04%
Signal to noise ratio: 105dB
Frequency response: 14hz-100khz (maximum range calculated by RC high-low power circuit: 3.29 hz-482.29 kHz)
Power supply voltage: recommended ±25V (highest voltage shall not exceed ±30V, full bridge rectification of 18V is 25V)
PCB size of engineering drawing is 46.5*37.5mm

Los kits DIY requieren de conocimientos elementales de electrónica para poder armarlos y que funcionen. Si Ud no esta seguro de poder armar este kit, por favor no compre el producto. No se brinda asistencia técnica para su armado y/o puesta en servicio. Además los kits DIY no tienen devolución.