Conversor De Voltaje 10v A Frecuencia 10khz Itytarg

16434

Nuevo producto

Cod: GAW

Placa sin jumper

No es un modulo con salida PWM

Más detalles

20 artículos

compartir

$ 13.800,00 IVA Inc.

Más

  • Frequency voltage module is capable of generating a different frequency according to the input voltage highlands module. 0-10V voltage can be converted to the frequency of the pulse signal 0-10KHz
  • The output signal can be adjusted, you can adjust the potentiometer to calibrate the correspondence between voltage and frequency.
  • This module outputs can drive make pulse signal, and drives with matching To common anode connection, where relevant wiring OC-OUT: connected drive PUL- or PUL 12-30V, then drive PUL + or common + 5V (12V power supply when to a series resistor of 330R, when 13-24V power to string a 2.7K resistor current limiting).
  • Operating voltage: 13.5V-30V; controllable input voltage range: 0-10V; output frequency range: 0-10KHz.

Wiring Instructions:
 
VCC: Working power supply.
GND: Power ground.
IN+: Input voltage.
IN-: Input ground.
OCOUT: Signal collector output port (use this output port when equipped with a driver).
FOUT: Frequency output port (common frequency output port).
Two independent outputs, OC-OUT is NPN and FREQ-OUT is IC output. The common cathode end is matched with the negative GND of the power supply. When the common anode wiring is used with the power supply, when the common anode wiring is 13-24V, it is necessary to string a 2.7KR resistor, and the common anode wiring is 12V power supply. To string a 330R resistor.
 
Instructions:
 
The frequency pulse signal is connected to F, and there is a corresponding voltage output at the VOUT terminal.
Input and output correspondence:
1V = 1KHz
10V = 10KHz
If there is a deviation in the correspondence when using, you can adjust the potentiometer on the board to calibrate.
 

2 productos más en la misma categoría: