Valvula 3/4 Solenoide 12v Agua Rob-10456 Normal Cerrada Arduino Itytarg

VALVULA SOLENOIDE 12V

Válvula solenoide a 12v implementada para el control de paso de liquido, funciona a 12v , el solenoide se libera por gravedad por lo cual se debe tener una presión suficiente para liberarlo el cual es de una presión mínima de 3PSI

12V Solenoid Valve - 3/4" (Sparkfun ROB-10456)

Have you ever wanted to control the flow of a liquid using your computer or microcontroller, but didn't know how? Well, here's how: The 12V solenoid controlled fluid valve. Simply connect a fluid source to the 3/4" threaded inlet and it will interrupt the flow until 12V is applied to the fast-on connectors on the solenoid.

Note: This is not a gravity-feed solenoid. This means that you will need enough water pressure to fully open the valve. Check the datasheet below for exact details. It operates at a minimum of around 3 PSI, allowing around 3 L/min of flow. Although the datasheet shows the valve working at 220 VAC, it's actually 12 VDC. Our 350 GPH pump does not have enough pressure for this valve. A garden hose or other pressurized system should work just fine.

Type Solenoid Valve
Function 2/2 Normally Closed
Actuator Type -
Operating Pressure 2.9 ~ 116.03 PSI (0.2 ~ 8 bar)
Orifice Diameter -
Fluid Type Liquid
Connection Method Threaded 3/4" NPT
For Use With/Related Products -
Mounting Type Free Hanging (In-Line)
Ingress Protection -
Operating Temperature 0°C ~ 75°C
Mechanical Life 1,000,000 Cycles

Datasheet