Mx1919 Dual Driver Controlador Motor Puente H 2.5a 10v Itytarg

Features

 2.5A power-enhanced motor drive module with silicone wire, pin header, terminal. The power supply voltage is 2V10V, which can drive two DC motors or one 4-wire 2-phase stepping motor at the same time. It can realize the function of forward and reverse and speed regulation, with thermal protection and automatic recovery. 
 It adopts imported professional motor drive chip and built-in low-conduction internal resistance MOS switch tube. It has very low heat, no heat sink, small size and power saving. It is an ideal choice for battery power supply. 
 Dual 2.5A*2, is an enhanced version of 1.5A motor drive, built-in overheat protection circuit, no need to worry about motor stalled burnout, automatic recovery after temperature drop. 

 Note:

1. The connection between the positive and negative terminals of the power supply will definitely cause damage to the circuit. 

 2. The output is short-circuited to the ground or short-circuited at the output, and the chip is thermally protected. However, if the voltage is close to or exceeds 10V and the peak current greatly exceeds 2.5A, the chip will burn out.

Description

Descriptions:
1. (L298N is a transistor switch inside, low efficiency, high heat, heat dissipation, bulky, L298N on the market is very easy to burn out, no original chip is used, this product can be replaced.)

2. Dual 2.5A*2, is an enhanced version of 1.5A motor drive, built-in overheat protection circuit, no need to worry about motor stalled burnout, automatic recovery after temperature drop. (Currently, the smart car voltage and current in the market are within this range)

3. Small size, light weight, 0 standby current

Parameters:

1. Two-way H-bridge motor drive, can drive two DC motors or one 4-wire two-phase stepper motor at the same time;

2. Module supply voltage 2V-10V;

3. Signal input voltage is 1.8-7V;

4. Single working current 2.5A, low standby current (less than 0.1uA);

5. Built-in anti-common state conduction circuit, when the input terminal is suspended, the motor will not malfunction;

6. Built-in overheat protection circuit (TSD) with hysteresis effect, no need to worry about motor stall;

7. Product size: 31*32*5mm (length, width and height), ultra-small size, suitable for assembly and vehicle;

8. Mounting hole diameter: 2 mm.

Note:

1. The connection between the positive and negative terminals of the power supply will definitely cause damage to the circuit.

2. The output is short-circuited to the ground or short-circuited at the output, and the chip is thermally protected. However, if the voltage is close to or exceeds 10V and the peak current greatly exceeds 2.5A, the chip will burn out.